Definition of Occupation and Class Codes

From Florida DBPR

General Terms

In general, the term “contractor” means the person who is qualified for, and shall only be responsible for, the project contracted for and means, except as exempted in this part, the person who, for compensation, undertakes to, submits a bid to, or does himself or herself or by others construct, repair, alter, remodel, add to, demolish, subtract from, or improve any building or structure, including related improvements to real estate, for others or for resale to others; and whose job scope is substantially similar to the job scope described in one of the subsequent paragraphs of this subsection. For the purposes of regulation under this part, “demolish” applies only to demolition of steel tanks over 50 feet in height; towers over 50 feet in height; other structures over 50 feet in height, other than buildings or residences over three stories tall; and buildings or residences over three stories tall.

A “certified contractor” means any contractor who possesses a certificate of competency issued by the department and who shall be allowed to contract in any jurisdiction in the state without being required to fulfill the competency requirements of that jurisdiction. Certified contractors are designated by an occupation code which begins with the letter “C“.

A “registered contractor” means any contractor who has registered with the department pursuant to fulfilling the competency requirements in the jurisdiction for which the registration is issued. Registered contractors may contract only in such jurisdictions. Registered contractors are designated by an occupation code that begins with the letter “R“.

A “swimming pool specialty contractor” means a sub-contractor whose scope of work is limited to the scope of work of their particular specialty license. Swimming pool specialty contractor licenses may be issued in the areas of layout, structural, excavation, trim, decking, piping, and finishes. Swimming pool specialty contractors may not contract directly with the public and must work under contract, under the supervision, and within the scope of work of a contractor licensed pursuant to Sections 489.105(3)(j) – (l), Florida Statutes.

Definitions including the occupation codes and class codes, where applicable

CG and RG – A “general contractor” means a contractor whose services are unlimited as to the type of work which he or she may do.

CB and RB – A “building contractor” means a contractor whose services are limited to the construction of commercial buildings and single-dwelling or multiple-dwelling residential buildings. These buildings cannot exceed three stories in height. A building contractor may also construct the “accessory use structures” in connection with these buildings. An accessory use structure would be a garage, guest house, garden shed, or other outbuildings. A building contractor is also a contractor whose services are limited to remodeling, repair, or improvement of any size building – if the services do not affect the structural elements of the building.

CR and RR – A “residential contractor” means a contractor whose services are limited to construction, remodeling, repair, or improvement of one-family, two-family, or three-family residences which are not more than two stories and the “accessory use structures” in connection with these buildings. An accessory use structure would be a garage, guest house, garden shed, or other outbuildings.

CS and RS – A “sheet metal contractor” means a contractor whose services are unlimited in the sheet metal trade and who has the experience and skill necessary for the manufacture, fabrication, assembling, handling, erection, installation, dismantling, conditioning, adjustment, insulation, alteration, repair, servicing, or design of ferrous or nonferrous metalwork of U.S. No. 10 gauge or it’s equivalent or lighter gauge. A sheet metal contractor may also work with other materials, including, but not limited to, fiberglass.

CC and RC – A “roofing contractor” means a contractor whose services are unlimited in the roofing trade. Roofing contractors have the experience, knowledge, and skill to install, maintain, repair, alter, extend, or design and use materials and items used in the installation, maintenance, extension, and alteration of all kinds of roofing, waterproofing, and coating, except when the coating is not represented to protect, repair, waterproof, stop leaks or extend the life of the roof. The scope of work of a roofing contractor also includes required roof-deck attachments and any repair or replacement of wood roof sheathing or fascia as needed during roof repair or replacement.

CA and RA – A “class A air-conditioning contractor” means a contractor whose services are unlimited in the execution of contracts requiring the experience, knowledge, and skill to install, maintain, repair, fabricate, alter, extend, or design central air-conditioning, refrigeration, heating, and ventilating systems. Class A Contractors may also execute contracts requiring experience in the installation, maintenance, repair, fabrication, alteration, extension, or design of ductwork in connection with a complete system but only to the extent that such ductwork is performed by the contractor as is necessary to complete an air-distribution system, boiler and unfired pressure vessel systems, and all appurtenances, apparatus, or equipment used in connection with them. A “class A air-conditioning contractor” shall not perform any work such as liquefied petroleum or natural gas fuel lines within buildings, potable water lines or connections, sanitary sewer lines, swimming pool piping and filters, or electrical power wiring.

CA and RA – A “class B air-conditioning contractor” means a contractor whose services are limited to 25 tons of cooling and 500,000 BTU of heating in any one system in the execution of contracts requiring the experience, knowledge, and skill to install, maintain, repair, fabricate, alter, extend, or design central air-conditioning, refrigeration, heating, and ventilating systems, including ductwork in connection with a complete system. A “class B air-conditioning contractor” shall not perform any work such as liquefied petroleum or natural gas fuel lines within buildings, potable water lines or connections, sanitary sewer lines, swimming pool piping and filters, or electrical power wiring.

CA and RA – A “class C air-conditioning contractor” means a contractor whose business is limited to the servicing of air-conditioning, heating, or refrigeration systems, including any duct cleaning and equipment sanitizing which requires at least a partial disassembling of the system, and whose certification or registration, issued pursuant to this part, was valid on October 1, 1988. NOTE: No person not previously registered or certified as a “class C air-conditioning contractor” as of October 1, 1988, shall be so registered or certified after October 1, 1988.

CM and RM – A “mechanical contractor” means a contractor whose services are unlimited in the execution of contracts requiring the experience, knowledge, and skill to install, maintain, repair, fabricate, alter, extend, or design central air-conditioning, refrigeration, heating, and ventilating systems, including ductwork in connection with a complete system. A “mechanical contractor” shall not perform work that involves potable water lines or connections, sanitary sewer lines, swimming pool piping, and filters or electrical power wiring.

CP and RP – A “commercial pool/spa contractor” means a contractor whose scope of work involves, but is not limited to:
•  the construction, repair, and servicing of any swimming pool, or hot tub or spa, including the repair or replacement of existing equipment or the installation of new equipment, as necessary;
•  the layout, excavation, operation of construction pumps for dewatering purposes, steelwork, installation of light niches, construction of floors, guniting, fiberglassing, installation of tile and coping, installation of all perimeter and filter piping, installation of all filter equipment and chemical feeders of any type, plastering of the interior, construction of decks, construction of equipment rooms or housing for pool equipment, and installation of package pool heaters; and
•  includes the scope of work of a swimming pool/spa servicing contractor.
•  A “commercial pool/spa contractor” cannot perform direct connections to a sanitary sewer system or to potable water lines.
•  The installation, construction, modification, or replacement of equipment permanently attached to and associated with the pool or spa for the purpose of water treatment or cleaning of the pool or spa requires licensure; however, the usage of such equipment for the purposes of water treatment or cleaning shall not require licensure unless the usage involves construction, modification, or replacement of such equipment.

CP and RP – A “residential pool/spa contractor” means a contractor whose scope of work involves, but is not limited to:
•  the construction, repair, and servicing of any residential swimming pool or hot tub or spa including the repair or replacement of existing equipment or the installation of new equipment, as necessary;
•  the layout, excavation, operation of construction pumps for dewatering purposes, steelwork, installation of light niches, construction of floors, guniting, fiberglassing, installation of tile and coping, installation of all perimeter and filter piping, installation of all filter equipment and chemical feeders of any type, plastering of the interior, construction of decks, installation of housing for pool equipment, and installation of package pool heaters; and
•  includes the scope of work of a swimming pool/spa servicing contractor.
•  A “residential pool/spa contractor” cannot perform direct connections to a sanitary sewer system or to potable water lines.
•  The installation, construction, modification, or replacement of equipment permanently attached to and associated with the pool or spa for the purpose of water treatment or cleaning of the pool or spa requires licensure; however, the usage of such equipment for the purposes of water treatment or cleaning shall not require licensure unless the usage involves construction, modification, or replacement of such equipment.

CP and RP – A “swimming pool/spa servicing contractor” means a contractor whose scope of work involves the servicing and repair of any swimming pool or hot tub or spa. The scope of such work may include any necessary piping and repairs, replacement and repair of existing equipment, or installation of new additional equipment as necessary. The scope of such work includes:
•  the reinstallation of tile and coping, repair and replacement of all piping, filter equipment, and chemical feeders of any type, replastering, reconstruction of decks, and reinstallation or addition of pool heaters;
•  the installation, construction, modification, substantial or complete disassembly, or replacement of equipment permanently attached to and associated with the pool or spa for the purpose of water treatment or cleaning of the pool or spa requires licensure; and
•  however, the usage of such equipment for the purposes of water treatment or cleaning shall not require licensure unless the usage involves construction, modification, substantial or complete disassembly, or replacement of such equipment.

CF and RF – A “plumbing contractor” means a contractor whose contracting business consists of the execution of contracts requiring the experience, financial means, knowledge, and skill to install, maintain, repair, alter, extend, or, when not prohibited by law, design plumbing. A plumbing contractor may install, maintain, repair, alter, extend, or design the following without obtaining any additional local regulatory license, certificate, or registration:
•  sanitary drainage or storm drainage facilities;
•  venting systems; public or private water supply systems;
•  septic tanks; drainage and supply wells;
•  swimming pool piping;
•  irrigation systems; or
•  solar heating water systems and all appurtenances, apparatus, or equipment used in connection with these, including boilers and pressure process piping and including the installation of water, natural gas (excluding liquid petroleum gases), and storm and sanitary sewer lines; and
water and sewer plants and substations;
•  the design and installation, maintenance, repair, alteration, or extension of air-piping, vacuum line piping, oxygen line piping, nitrous oxide piping, and all related medical gas systems;
•  fire line standpipes and fire sprinklers to the extent authorized by law; ink and chemical lines;
•  fuel oil and gasoline piping and tank and pump installation, except bulk storage plants; and
•  pneumatic control piping systems.

CU and RU – An “underground utility and excavation contractor” means a contractor whose services are limited to the construction, installation, and repair of:
•  main sanitary sewer collection systems;
•  main water distribution systems;
•  storm sewer collection systems;
•  the continuation of utility lines from the main systems to a point of termination up to and including the meter location for the individual occupancy, sewer collection systems at property line on residential or single-occupancy commercial properties, or on multioccupancy properties at manhole or wye lateral extended to an invert elevation as engineered to accommodate future building sewers, water distribution systems, or storm sewer collection systems at storm sewer structures; and
•  install empty underground conduits in rights-of-way, easements, platted rights-of-way in new site development, and sleeves for parking lot crossings no smaller than 2 inches in diameter, provided that each conduit system installed is designed by a licensed professional engineer or an authorized employee of a municipality, county, or public utility and that the installation of any such conduit does not include installation of any conductor wiring or connection to an energized electrical system.
•  An underground utility and excavation contractor shall not install any piping that is an integral part of a fire protection system as defined in s. 633.021 beginning at the point where the piping is used exclusively for such system.

CV – A “solar contractor” means a contractor whose services consist of the installation, alteration, repair, maintenance, relocation, or replacement of solar panels for potable solar water heating systems, swimming pool solar heating systems, and photovoltaic systems and any appurtenances, apparatus, or equipment used in connection with these systems.

PC – A “pollutant storage systems contractor” means a contractor whose services are limited to the installation, maintenance, repair, alteration, extension, or design and use of materials and items used in the installation, maintenance, extension, and alteration of, pollutant storage tanks.

SCC, RX – A “specialty contractor” means a contractor whose scope of work and responsibility is limited to a particular phase of construction and whose scope is limited to a subset of the activities described in the categories established in s. 489.105, F.S. Specialty contractors include Specialty Structure Contractors, Gypsum Drywall Contractors, Irrigation Contractors, Glass and Glazing Contractors, Swimming Pool Specialty Contractors, Marine Specialty Contractors and Tower Specialty Contractors.

6 comments

  • Section 489.117 (4) (a) states:
    (4)(a) A person holding a local license whose job scope does not substantially correspond to either the job scope of one of the contractor categories defined in s. 489.105(3)(a)-(o), or the job scope of one of the certified specialty contractor categories established by board rule, is not required to register with the board to perform contracting activities within the scope of such specialty license.

    Where do I find the “certified specialty contractor categories established by board rule”.
    Specifically Painting!

  • There seems to be absolutely zero consideration for a Commercial Diving Services Contractor.

  • do you need a license to perform water mitigation, i.e., removal of affected materials, sanitizing and anti microbial applications and drying? An example would be clearing out a category 3 flooded house and drying it out for others to do repair work.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.